Acrylic resin is a type of plastic that, when heated, becomes a liquid, assuasive for pouring and moulding into figurines and statues. Acrylic resin is strong and durable enough for outdoor use along with indoor displays. When accidents occur, statues of this type can crack or chip, and parts can suspension off entirely. However, acrylic resin statues are easily repairable.

  • Acrylic resin is a type of plastic that, when heated, becomes a liquid, allowing for pouring and moulding into figurines and statues.

Wipe the statue with a damp rag or wash with soapy h2o to remove dirt and dust from crack.

Use a flexible putty knife or corner of a credit bill of fare to remove dust and dirt from within the crack.

Employ a small amount of water to the fissure to dampen the within of the cleft and reach a better mucilage bond.

Utilize a line of cyanoacrylate glue to the crack; build the glue up until flush with the surface of the statue. Cyanoacrylate glue dries within seconds of awarding and will bail better when the crack is damp because of the chemical reaction between the glue and water.

  • Apply a line of cyanoacrylate gum to the crevice; build the glue upwards until affluent with the surface of the statue.

Buff the repair line smoothen with a micromesh sanding pad and touch on up the impairment with acrylic pigment.

Remove small, loose pieces of acrylic resin with a fingernail or edge of a credit card.

Wipe the damaged area with a damp cloth to remove dirt and debris.

Place a plastic bag over fingertips or wear latex gloves to keep fingers free of hard-to-remove putty, then printing ii-part epoxy putty firmly into the chipped area. Two-part epoxy putty consists of claylike putty and a hardening agent.

Press and mould the putty to match the surface of the statue and allow the putty to dry completely, usually within v to 10 minutes.

Sand the repair with extra-fine sandpaper, wipe away dust, rub with a micromesh sanding pad, wipe away dust and paint the area with matching acrylic paint.

  • Press and mould the putty to match the surface of the statue and let the putty to dry completely, usually within v to 10 minutes.
  • Sand the repair with actress-fine sandpaper, wipe away dust, rub with a micromesh sanding pad, wipe away grit and paint the expanse with matching acrylic pigment.

Wipe the statue and broken edges clean with a damp rag.

Sand the edges of the break lightly with fine-grit sandpaper and remove loose pieces effectually the suspension. Wipe off sanding dust with a damp cloth.

Wet the edges of the break lightly with apparently h2o and apply cyanoacrylate glue. Chop-chop replace the broken piece considering the glue dries within seconds.

Fill in uneven, small lines around the break with cyanoacrylate gum or big gaps with two-office epoxy putty. Allow to dry fully, generally inside less than 10 minutes.

Buff the repair smooth with actress-fine sandpaper and and then rub with a micromesh sanding pad. Apply acrylic paint to further disguise the damage and restore the statue.

Piece of work in a well-ventilated room when using cyanoacrylate gum.